-49-
Operation method-1 :
(A) Turn off the projector. Next, connect the flexible cables of the LCD
panels to the assembly Main. Turn on the projector.
(B) Enter the mode of “service adjustment”. (Refer to “service adjust-
ment” on page 35.)
(C) Select each Group and Item No..
Full lamp mode : Select “ 930-0 ”
To light only the “Lamp-1” : Select “ 930-1 ”
To light only the “Lamp-2” : Select “ 930-2 ”
If the data value appears “11” then go to (D),
or appears “0” then set the data value to “10” and go to (D),
or appears “10” then wait until it is changed to “0” and set the data
value to “10” and go to (D).
(D) Press power on/off button to quit the service mode.
(E) Turn off the projector. Remove the flexible cables on LCD panels from
the assembly Main. And turn on the projector.
Fine adjustment-1 : Integrator lens out
1. Loosen three screws-B on the Integrator lens out unit.
2. Insert a slot screwdriver into slot-A on the Integrator lens out
unit, turn and adjust it so that the screen may obtain even color.
3. Tighten the three screws B to fix the integrator lens-out.
Fine adjustment-2 : Integrator lens in
1. Loosen 2 screws-A on the Integrator lens in unit.
2. Insert a slot screwdriver into slot-C on the Integrator lens in
unit, turn and adjust it so that the screen may obtain even color.
3. Tighten the 2 screws A to fix the integrator lens-in.
To Next Page
Loading...
