Control of W-2WAY ECO-i SYSTEM
5. Schedule Timer
STEP 4 Press the HOLIDAY button to enter the holiday.
The normal display returns.
To halt programmed operation for one week or more, you can disable all timer programs.
Once the timer has been disabled, programmed operations are not run until the below procedure is performed.
NOTE
During installation, the remote controller may be set to disable the timer for individual groups. In this state, the timer is disa-
bled only for the selected group, therefore press the GROUP button to confirm which group is selected.
Hold down the TIMER OFF button for more than
2 seconds
To turn the timer back ON, hold down the TIMER
OFF button for more than 2 seconds
appears on the display. The timer is
disabled from the next scheduled program.
goes out and the timer is enabled
from the next scheduled progra
m.
L L
To Next Page
Loading...
