Sanyo SUPER BL PY - Page 118

7. EXPLANATION OF PARAMETERS
7－23
●
Automatic notch filter tuning (Tune IBEF) procedure
Fig. 7-13 Automatic Notch Filter Tuning Operation
After automatic notch filter tuning is completed, press the key to return to the set screen from the
ready screen, and then return to the initial screen using the key.
When the initial screen is displayed, the "OVF (excessive deviation)" alarm occurs.
When the automatic notch filter tuning is disabled by a main circuit power off status or an alarm, the
following is displayed:
＊
Test 5
Tune Not Ready
The automatic notch filter tuning is enabled, the Tune IBEF set screen appears.
Set page 5 using the or
key.
Select current command peak in tuning using the or key.
(2 ways of Ic=Ir, Ic=Ist. Ir: rated current, Ist: user setting value MODE8-3)
* Test 5
Tune IBEF #####
* Test 5
Tn_F Rdy Y=3,N=0
Flickers
3
Test screen
Tune IBEF set screen
During tuning
Completion Error
.... During notch tuning,
an error occurs.
* Test 1
Tn_F Completed
A
fter
completion,
the buzzer
sounds.
A
short
beep is
sounded.
* Test 5
Tn_F Error
* Test 5
Tn_F Running
Stop
Execute
: The servo ready signal is turned
off and the servo is turned on.
WR
0
0
Tn_F ready
screen
: Servo ON
cancel
(Servo OFF)
: Cancel
(Servo OFF)
0