0. SAFETY PRECAUTIONS
0－8
CAUTION
<Wiring>
9. Don't measure insulation resistance and dielectric strength, or these units may
be damaged.
When you have to measure them, please contact us.
10. Arrange cables in accordance with the Technical Standard for Electric Facilities
and the Extension Rules.
Otherwise, cables may be burnt and fire may occur.
11. Arrange cables correctly and securely, or the motor may run away and you may
be injured.
12. Don't apply static electricity or high voltage to the motor sensor terminal, or the
motor may get out of order.
<Installation>
13. Don't climb up these units nor place heavy substance on them, or you may be
injured.
14. Don't stop the air inlets and outlets nor put foreign matters in them, or fire may
occur.
15. Be sure to observe the direction of installation, or a trouble will occur.
16. Decide the distances between the amplifier, the inside surface of the control
panel and other equipment in accordance with the User's Manual.
Otherwise, troubles may occur.
17. Don't shock these units badly, or they may be get out of order.
18. During installation, take an extreme care not to drop nor overturn these units, or
you may face serious dangers.
When raising the motor, use the lifting bolt if it is fitted.
19. Never install these units where they are exposed to splash of water, in corrosive
or inflammable gas atmosphere or near combustibles.
Otherwise, fire may occur or they may get out of order.
20. Install them to any of nonflammables like metal, or fire may occur.
To Next Page
Loading...
