39 English
INSTALLING THE BATTERY PACK AND CARD
3 Close the battery/card cover.
<When removing the card...>
h To remove the card, press it down,
and then release. The card will
protrude slightly, and you can then
pull it out.
CAUTION
i Do not attempt to forcibly remove the card.
i Never remove the card when the multi-indicator is flashing red. In doing so,
you risk losing the data stored in the card.
NOTE
About the internal backup battery
i This camera’s internal battery serves to maintain the date and time
settings, as well as the shooting settings. The backup battery will be fully
charged when the batteries are kept in the camera continuously for about 2
days. In the fully charged state, the backup battery will maintain the
camera settings for about 7 days.
When not using the camera for a long time, remove the battery pack
i A small amount of power is still used even if the camera is turned off, and it
is therefore recommended that the batteries be removed from the camera
if it is not going to be used for a long time. Note that when the batteries are
removed for a long period, the time and date settings may be cleared.
Before using your camera again, be sure to confirm that the camera
settings are correct.
To Next Page
Loading...
Need help?
General
