Operating Instructions Stainless Steel In-Line Filter Holder Type 16274 15
Installation
t Place the filter support on the perforated sheet.
t Screw the other tube nozzle into the thread on the side of the upper part
of the device.
t Push the second O-ring into the groove on the inside of the upper part
of the device.
t Place the upper part of the device on a stable surface, e.g. a table, with
the inside facing upwards.
t Insert the backflow prevention device so that the lugs face downwards
and one of the lugs is in line with the valve.
t Push the backflow prevention device down onto the inside of the upper
part of the device and turn it until the lugs are in the recesses provided
for that purpose.
t Seal the filler opening with the filler opening cap.
To Next Page
Loading...
