22 Operating Instructions Stainless Steel In-Line Filter Holder Type 16274
Maintenance Schedule
7 Maintenance Schedule
Interval Component Action Chapter,
page
Target group
Before each use of the
device
Seals Check for damage and
replace if necessary
User
After each use of the device Device Clean 5.1.2, 17 User
Before and after each
sterile filtration
Device Perform an integrity test 6.1, 20 User
Depending on application.
Must be determined by the
operator
Seals Replace User
8 Malfunctions
Malfunction Cause Solution Chapter,
page
The device has a leak. A seal is damaged. Check and replace the
seals.
The valve has a leak. The seal is damaged. Replace the seal.
The valve cannot be turned. The valve is dirty. Clean the valve. 5.1.2, 17
The membrane filter is torn during
autoclaving.
The membrane filter was not
inserted without tension.
Insert a new membrane
filter without tension.
5.2, 18
To Next Page
Loading...
