Operating Instructions Stainless Steel In-Line Filter Holder Type 16274 7
Safety Instructions
2 Safety Instructions
2.1 Intended Use
The device was developed for sterile filtration of difficult-to-filter liquids
(e.g. serum) and particle removal from solvents or viscous liquids (e.g.
photoresist) and is intended for general laboratory use.
The device is exclusively designed for use in accordance with these
instructions. Any further use beyond this is considered improper.
If the device is not used properly: The device’s protective systems may be
impaired. This can lead to unforeseeable personal injury or property
damage.
Operating conditions for the device
Do not use the device in potentially explosive environments. Only use the
device indoors.
The device may only be used with the equipment and under the operating
conditions described in the Technical Data section of these instructions and
on the device’s type plate.
Modifications to the device
You may not modify or repair the device or make any technical changes.
Any retrofitting or technical changes to the device are only permitted with
prior written permission by Sartorius Stedim Biotech.
2.2 Personnel Qualification
Persons who do not possess adequate knowledge about how to use the
device safely may injure themselves and other persons.
If a particular qualification is required for an activity: The target group will be
specified. If no qualification is specified: The activity may be carried out by
the “operator” target group.
2.3 Proper Working Order of the Device
A damaged device or worn parts may lead to malfunctions or cause hazards
which are difficult to recognize.
t Only operate the device when it is safe and in proper working order.
t Comply with the maintenance intervals (for intervals and maintenance
work, see Chapter “7 Wartungsplan”, page 56).
t Have any malfunctions or damage repaired immediately by Sartorius
Service.
To Next Page
Loading...
