resolution. The resolution settings are either display resolution, display resolution
10-fold or display resolution 100-fold.
Entering the reference weight
The reference weight (e.g., the weight of one meter of electrical cable) can be
entered using the keypad and saved by pressing the O key.
Reading the reference piece weight
The reference weight can be read using a barcode scanner.
h
The entered value remains active until deleted by pressing the c key or until
overwritten by a new value. It remains saved after the scale is switched off.
Preparation t Open the APPLIC. / APPLIC.1 / Neutr.M menu.
Available parameter settings * = Factory setting
MIN.INIT Minimum load for initialization 3.6
1 digit 1 digit 3.6.1*
2 digit 2 digits 3.6.2
5 digit 5 digits 3.6.3
10 digT. 10 digits 3.6.4
20 digT. 20 digits 3.6.5
50 digT. 50 digits 3.6.6
100 diG. 100 digits 3.6.7
200 diG. 200 digits 3.6.8
500 diG. 500 digits 3.6.9
1000 dI. 1000 digits 3.6.10
RESOLUT Resolution for calculation of reference value 3.9.
DISP.ACC Display accuracy 3.9.1*
10 FOLD Display accuracy + 1 decimal place 3.9.2
100FOLD Display accuracy + 2 decimal places 3.9.3
DEC.PLCS Decimal places in displayed result 3.10
NONE None 3.10.1*
1 DEC.PL 1 decimal place 3.10.2
2 DEC.PL 2 decimal places 3.10.3
3 DEC.PL 3 decimal places 3.10.4
SAVE WT. Parameter for saving weight values 3.11
STABIL. With stability 3.11.1*
ACC.STAB With increased stability 3.11.2
REF.WP Reference weighing instrument 3.13.
NO WP No weighing platform selected 3.13.1*
wp 1 Weighing platform WP1 3.13.2
wp 2 Weighing platform WP2 3.13.3
) t To save the setting, press the ) key.
( ( ... t To exit setup: Press the ( key several times.
60 Operating Instructions Combics Indicators
Operation
To Next Page
Loading...
Need help?
General
