10
Connecting the Scale to AC Power
● Check the voltage rating and the plug design
– If they do not match,
contact your Sartorius office or dealer
Use only:
– Original Sartorius AC adapters
– Power supplies approved by a certified or authorized technician
k To use a main feeder cable from the ceiling or a CEE plug, have this
equipment installed or mounted by an authorized technician in your facilities
k To use an external rechargeable battery pack; see “Accessories” in the
“Overview” section
● Insert the right-angle plug into the jack and use a screwdriver to tighten the
slotted-head screw
● To energize the scale with AC power:
Plug the AC adapter into a wall outlet (mains)
Connecting Electronic Peripheral Devices
● Make absolutely sure to unplug the scale from AC power before you
connect or disconnect a peripheral device (printer or PC) to or from the
interface port
Safety Precautions
Information on Radio Frequency Interference
Note:
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct the
interference at his own expense. Changes or modifications not expressly approved
by Sartorius AG could void the user’s authority to operate the equipment.
The AC adapter rated to Class 2 can be plugged into any wall outlet
without requiring any additional safety precautions. The ground or earth
terminal is connected to the scale housing, which can be additionally
grounded, if required. The data interface is also electrically connected to
the scale housing (ground).
Warmup Time
To deliver exact results, the scale must warm up for at least 30 minutes after
initial connection to AC power or after a relatively long power outage. Only
after this time will the scale have reached the required operating temperature.
Using Verified Scales as Legal Measuring Instruments in the EU*:
k Make sure to allow the scale to warm up for at least 24 hours after
initial connection to AC power or after a relatively long power outage
* including the Signatories of the Agreement on the European
Economic Area
To Next Page
Loading...
