Operation
Basic Weighing Function
Features
– Zeroing the balance
You can zero the balance within the
entire weighing range, up to the maxi-
mum capacity.
Preparation
§ Switch on the balance: press the e
key
§ If necessary, zero the balance: press the
(Zero) key
$ If necessary, change the configuration
settings:
see the chapter entitled “Configuration”
$ If desired, load the factory settings:
see the chapter entitled “Configura-
tion,” menu item 9.– 1
Additional functions:
$ Switching off the balance: press the
e key
$ Battery operation: automatic shut-off
after 2,5 or 10 minutes; see chapter on
configuration. Example: 2 minutes.
If the weight readout remains
unchanged and no keys are pressed for
at least two minutes, the battery symbol
“ “ starts flashing. After another
2 seconds, the balance shuts off auto-
matically, unless a key is pressed.
Description of the Keys
e switches the balance on and off or
switches it to the standby mode.
Battery operation: on; turns
backlight on; off
(Zero) Zeros the balance; press and hold
2 seconds: opens the application
menu
(Cal) Starts calibration/adjustment
(F) Starts an application program;
Scrolling in application menu,
configration menu and calibra-
tion menu
(Enter) Confirms the selected setting;
Exits application, configuration &
calibration menu if key is pressed
and held for more than 2 seconds.
(Print) Generates a printout or data
output
88
To Next Page
Loading...
Need help?
General