Purpose
This function enables you to print out
weights, other measured values and IDs.
You can format the printout to meet
different requirements.
Features
Line format: you can configure a data
ID code with up to 6 characters at the
beginning of each of the values to be
printed
Weight ID:
You can configure an extra line for
identification of each weighed or
calculated value using the code
S ID
Print application parameters:
You can generate a printout of the val-
ues configured for initialization of
an application before printing the
measured results
ISO/GLP-compliant printout:
You can print out parameters relating to
the weighing conditions
Print animal weights:
Application-defined, automatic printout
of animal weights or of animal weights
plus calculated weights after averaging
Optimizing interfaces:
– Use the highest possible baud rate
– Turn off interfaces that are not in use
– Optimize the amount of data to be
transfered
128
Output to the Interface Ports
Print Mode Trigger Operating mode: PERIPHERALS
PERIPHERALS SBI xBPI
ESC P not possible
(PERIPHERALS)
Application PRINT key Prints individual
on balance printout or configured
printout according to
menu setting on
(Indiv.) PRINT key on
Printout: printer, or PRINTER, Prints individual
ESC P PERIPHERALS or both printout or configured
(PRINTER) printout on PRINTER,
if “on” selected in
menu
Application
Autoprint: ESC P Turns autoprint function not possible
(PERIPHERALS) on/off, if autoprint
can be stopped;
PRINT key otherwise, prints Turns autoprint function
on balance individual or on/off, if autoprint
configured printout can be stopped;
on PRINTER otherwise, prints
individual or
Cyclical output to configured printout
PERIPHERALS on PRINTER
PRINT key Prints individual Prints individual
on printer, or configured or configured
or ESC P printout on PRINTER printout on PRINTER
(PRINTER)
Application
Printer Interface
Type of interface: Serial interface port
Operating mode: Full duplex
Standard: RS-232
Interface connector: D-Sub female connector, 25-contact
Transmission rates*: 150; 300; 600; 1200; 2400; 4800;
9600 or 19,200 baud
Parity*: Space, uneven, even
Character transmission*: Start bit, 7/8-bit ASCII; parity, 1 or 2 stop bits
Handshake: For 2-wire interface: software (XON/XOFF);
for 4-wire interface: hardware (CTS/DTR)
Compatible devices: YDP02, YDP03, YDP01IS, YDP02IS, YDP01IS Label,
YDP02IS Label printers; universal printers, YDP04IS,
YDP04IS Label
Manual print mode Without stability, after stability
Auto print mode Only application-defined output
Data output format
of the balance: 16 characters, 22 characters
* depends on the operating mode (see page 124)
Printouts
To Next Page
Loading...
