83
Example
Differential weighing: Consecutive individual weighing; select lot, determine the difference in weight between initial weights and backweights
of two samples; generate and printout statistics; do not generate any individual and backweighing printouts
Settings (changes in the factory settings required for this example):
Setup: Application parameters: Application 1: Differential weighing: Weighing sequence: Consecutive individual weighing
Setup: Application parameters: Application 1: Differential weighing: Save statistics: Yes
Setup: Application parameters: Application 1: Differential weighing: Generate printout: No
Step Press key(s) (or follow instructions) Display/Output
1. Turn on the balance and e
select the settings listed above
2. Start differential weighing
Start soft key
(if necessary, select consecutive
Wt.seq soft key
individual weighing)
3. Create or select lot
Lot soft key
– select:
q or Q soft key
continue with step 7.
– create: see step 4.
4. Select “Lot name”
Create soft key
5. Enter lot name a
ABCDEF soft key(s)
C soft key
GHIJKL soft key(s)
H soft key
1 2 3 4
6. Confirm lot name input
l soft key
7. Activate weight readout
oo soft key
LOTS: 985 Smpl avail.
CH0001 4 Samples T,N,R(1)
CH0002 8 Samples T,N,R(1)
CH1234 0 Samples
oo Delete qQ SampleCreate
LOTS: 985 Smpl avail.
CH0001 4 Samples T,N,R(1)
CH0002 8 Samples T,N,R(1)
oo Delete qQ SampleCreate
To Next Page
Loading...
