9
Startup
Install components
(3 - 1)
in the weighing chamber.
Connecting the Balance to Line Power
Your balance is powered by a portable power supply unit. Use a
screwdriver to adjust the voltage selector on the power supply
unit to the setting of your local line voltage (either 115 or 230
volts).
Voltage Selection
Make sure that the voltage rating printed on this unit is identical
to your local line voltage rating.
Write the new voltage setting on the manufacturer's label.
lf the voltage rating specified on the power supply or the plug
design does not match the rating or Standard you use, please
contact your Sartorius dealer.
Important Note
Only use original Sartorius power supplies identified by the Sar-
torius label. Use of power supplies made by other manufactur-
ers, even if these power supplies have a registered approval
rating from a national testing laboratory, requires the consent of
a certified Sartorius technician.
Plug the cord line into the power receptacle. Secure the
connection by tightening the knurled collar. Now plug the power
supply unit into a wall outlet.
To Next Page
Loading...
