Sartorius MW1 - SETUP; UTILIT 7

Setup
prtprot
6
7.10. Optional “UniCOM” interface
Print results when c pressed in
Totalizing and Net-total applications
7.10.1*
1)
Header lines 1, 2 (content: see menu codes 7.4.x)
7.10.2*
1)
Date and time
7.10.4*
1)
Weighing instrument designation
7.10.5*
1)
Result from the application program
7.10.7
1)
2 additional blank lines
7.10.8
1)
3 additional blank lines
7.13 GMP data record or printout
7.13.1 Off
7.13.2 On for one result
7.13.3 On for multiple result
7.14. Date/time printout line: Time not printed
7.14.1* Off
7.14.2 On
7.15. One-time automatic printout at stability
7.15.1* Off
7.15.2 On
7.16. FlexPrint
7.16.1* Off
7.16.2 On
7.17. Decimal separator
7.17.1* Period
7.17.2 Comma
9.1. Restore factory settings of the numeric menu for data protocol
9.1.1 Yes
9.1.2* No
utilit
7
Operation
(Display designation of this menu level: 7)
8.3. Keys
8.3.1* All available
8.3.2 All blocked
8.3.3 Keys 0, 1, 2, etc. blocked Midrics 2 only
8.3.5 ( key blocked
8.3.6 ) key blocked
8.3.7 k key block
8.3.9 p key block
8.3.12 c key blocked Midrics 2 only
8.3.13 r key blocked Midrics 2 only
8.3.14 O key blocked Midrics 2 only
8.3.15 W key blocked Midrics 2 only
8.3.16 I key blocked Midrics 2 only
8.3.18 d key blocked Midrics 2 only
8.7. Automatic shutoff of display and control unit
8.7.1 Automatic shutoff acc. to menu item 8.9.
8.7.2* No automatic shutoff
8.8. Display lighting
8.8.1* On
8.8.2 Off
8.8.3 Automatic shutoff acc. to menu item 8.9.
8.9. Timer mode
8.9.1* After 1 + 1 minute not in use
(after 1 min.: warning
2)
is displayed for 1 minute)
8.9.2 After 2 + 2 minutes not in use
(after 2 min.: warning
2)
is displayed for 2 minutes)
8.9.3 After 5 + 5 minutes not in use
(after 5 min.: warning
2)
is displayed for 5 minutes)
8.12. Show geographical data before calibration
8.12.1* No
8.12.2 Yes
9.1. Restore factory settings of the numeric operating menu
9.1.1 Yes
9.1.2* No
1)
More than one can be selected
2)
Warning: the W symbol and weighing platform numbers 1 and 2 flash simultaneously
30