12 PERFECTA-T SATEL
Having reviewed the list of problems, press to go back to the “System not ready”
message.
Failure of arming procedure
If, after the exit delay countdown expires, the system fails to arm, there are some problems
that did not exist before the exit delay countdown was started. Such restriction may be
imposed by standards, e.g. EN 50131 for Grade 2.
6.4 Disarming and alarm clearing
If the partition is armed and an alarm is triggered in it, disarming will be accompanied by the
alarm clearing.
Alarm clearing results in canceling the voice messaging about alarm (unless the
control panel has already managed to notify the users about the alarm).
6.4.1 Disarming and alarm clearing without partition selection
Enter the code and then press . Disarming / alarm clearing will take place in the
partitions to which you have access.
6.4.2 Alarm clearing without disarming
If the partition is armed and you want to clear the alarm without disarming the partition, enter
the code and then press , or (it is of no consequence which key you will
press). In the partitions you have access to, the alarm will be cleared.
You cannot clear the warning alarm without disarming the system first.
6.4.3 Disarming and alarm clearing in selected partition
1. Select the partition which is to be disarmed and/or where alarm is to be cleared (press
one of the keys: - partition 1; - partition 2).
2. Press . Backlight of the keys will start flashing, which indicates that the code must be
entered.
3. Enter the code.
4. Press
or .
5. Selected partition will be disarmed / alarm will be cleared.
6.5 Triggering the alarm from keypad
The installer can permit triggering alarms from the keypad. To trigger an alarm, do the
following:
fire alarm – press and hold down
for about 3 seconds,
medical (auxiliary) alarm – press and hold down
for about 3 seconds,
panic alarm – press and hold down for about 3 seconds. The installer defines whether
the loud panic alarm (indicated by the keypads) or the silent panic alarm (not indicated by
the keypads) will be triggered.
6.6 Turning the CHIME on /off
The CHIME is five short sounds by means of which the keypad will inform you e.g. that
a door / window is open. The installer defines which zones of the alarm system can trigger
the CHIME and whether it can be turned on/off by the users.
Press and hold down for about 3 seconds to turn on or off the CHIME signaling.
To Next Page
Loading...
