Satel PERFECTA-T - Advanced Features: Listening In and Keyfobs; Listening In Functionality; Keyfob Operation

SATEL PERFECTA-T 23
however grant them access to the partition 2). The option is available, if you have access
to the partition 1.
Partition 2 – if this option is enabled, the installer/service technician can operate the partition
2 (arm / disarm it, clear alarm, bypass / unbypass zones) and edit the users (he cannot
however grant them access to the partition 1). The option is available, if you have access
to the partition 2.
If there is no user in the alarm system having the SERVICE ACCESS right, the
installer/service technician has access to the alarm system (also by using the
PERFECTA SOFT program), can operate the partitions and edit the users.
6.19 Service mode
The SERVICE MODE function is only available after entering the service code. It allows you to
enter the service mode. After entering the service mode, the functions that allow you to
configure the alarm system will be displayed. For more information, please refer to the control
panel programming manual.
7. Listening in
If a microphone is connected to the alarm control panel, the installer can make the listen-in
function available to the users. This function allows you to listen in remotely, by using a
telephone, to what is going on in the protected facilities, e.g. to verify the alarm. You can use
the listening in functionality by:
 calling the control panel phone number,
 after having listened to the voice message by which the control panel will notify you about
a new event in the control panel.
Consult the installer to determine whether both ways of using the function are available, or
just one of them.
8. Keyfobs
You can operate the PERFECTA-T 32-WRL alarm system by using the MPT-350 keyfob. To
operate the PERFECTA-T 32 alarm system, you can use any SATEL 433 MHz keyfob,
provided that the 433 MHz keyfob receiver expansion module (INT-RX-S) is connected to the
control panel.
Fig. 2. MPT-350 keyfob.