Satel PERFECTA-T - Trouble Memory and Clearing; Output Control and System Tests; Controlling Outputs

20 PERFECTA-T SATEL
6.14.1 Information on system state
If the GRADE 2 option is enabled by the installer, the 7.SYSTEM STATE function, instead of the
7.TROUBLES function, is available in the user menu. When the function is running, the
following information is displayed:
 alarms,
 bypassed zones,
 troubles,
 partition status (disarmed or arming type).
6.14.2 What to do in the event of trouble
Each trouble poses a danger to proper functioning of the alarm system and should be
repaired as soon as possible. If necessary, consult the installer.
6.14.3 Trouble memory and clearing the trouble memory
The installer defines whether only the current troubles are to be presented, or also those
which have already ended. The flashing letter “M” in the upper right corner of the display
means that the trouble has already ended. You can clear the trouble memory after quitting
the function.
1. Press to quit the function.
2. The “Clear trouble memory? 1=Yes” message will appear on the display.
3. Press to clear the trouble memory (press , if you don’t want to clear the trouble
memory).
6.15 Output control
Using the keypad, you can control the operation of devices connected to the outputs (e.g. to
raise/lower roller blinds/shutters, turn on/off lighting or heating, etc.). The installer defines
how the outputs should work (whether the output will be activated for a defined time, or it will
remain active until deactivated by the user, timer, etc.).
6.15.1 Quick control of outputs
Consult the installer whether the quick control of outputs is available (the controllable outputs
must be assigned to the keys designated with digits). If the quick control is available, you can
turn ON/OFF devices connected to the outputs without having to enter the code.
Quick activation of output
Press the key to which the controllable output is assigned, and then
.
Quick deactivation of output
Press the key to which the control
lable output is assigned, and then .
6.15.2 Controlling the outputs by means of function
1. Enter the user menu and press to run 8.OUTPUTS CTRL. function.
2. Symbols illustrating the status of outputs you can control will be presented in the upper
line of the display:
– output is deactivated,
– output is activated.
The numbers above the display make identification of the outputs possible. If no symbol is
displayed below the number, you cannot control the output.