SATEL PERFECTA-T 5
companies offering the alarm system monitoring service undertake to intervene if specific
events occur (e.g. alarms, troubles, etc.).
rvice code – a code that allows access to the service mSe ode, as well as some functions in
Se control operability of the installed alarm
Si
of the alarm system to opening the housing of a device which is
Us
W
ng limited to signaling warning alarm in keypads
te is to be supervised (panic button, siren tamper contact,
Zo
n it is in the armed mode. Violations of the zone will be
ignored by the control panel.
that defined for the
ces
the user menu.
rvice technician – the person whose function is to
system and its components, as well as to eliminate possible problems. These duties can
be fulfilled by the installer or a person assigned by him.
ren/beacon – a device providing information about alarms or other events in the alarm
system by means of acoustic or optical signaling.
mper alarm – reactionTa
part of the alarm system, tearing off the device from the wall, cutting through the alarm
system cables, etc. Actions taken by the alarm system may be similar as in the event of
alarm, however, if the tamper alarm occurs, it is advisable to call in the installer so that he
can make a checkup.
er – a person which can operate the alarm system, using a code or remote control keyfob.
arning alarm – in some situations, when the alarm criteria are met, the alarm system does
not take up immediately all the actions provided for in the event of alarm. These actions
are postponed, reaction of the system bei
or on indoor sirens/beacons. Thus, the user who has made a mistake entering the
protected area (without disarming the system first), has some extra time to disarm the
system. Contact your installer to obtain detailed information on the situations when the
alarm will be preceded by warning alarm.
Zone – 1. a separated portion of the protected area that can supervised by a detector. 2. the
terminals on control panel/expander electronics board to which you can connect a detector
or another device whose sta
power supply output indicating loss of 230 V AC supply, etc.).
ne bypassing (inhibiting / isolating) – procedure preventing the alarm from being
triggered by the selected zone whe
Zone violation – a change of the zone status to another, different from
normal state (e.g. as a result of motion being sensed by the motion detector, gas being
sensed by the gas detector, etc.).
5. EN 50131 standard for Grade 2 consequen
If the installer has configured the control panel in compliance with the EN 50131 standard
n provided in the keypads by means of LEDs, display and sound
k arming from keypad (without entering the code) is not available.
4. Arming may be impossible, if one of the situations provided for in the standard occurs
(zone violation, trouble).
How requirements of the standard affect the use of the control panel is described in detail
hereunder.
requirements for Grade 2:
1. The user codes should be composed of at least 5 characters.
2. The amount of informatio
signaling is limited.
3. The quic
To Next Page
Loading...
