Satel Versa - Page 19

SATEL VERSA 17
77. Output 7 deactivation
78. Output 8 deactivation
79. Output 9 deactivation
80. Output 10 deactivation
81. Output 11 deactivation
82. Output 12 deactivation
91. Output 1 switchover
92. Output 2 switchover
93. Output 3 switchover
94. Output 4 switchover
95. Output 5 switchover
96. Output 6 switchover
97. Output 7 switchover
98. Output 8 switchover
99. Output 9 switchover
100. Output 10 switchover
101. Output 11 switchover
102. Output 12 switchover
Contact the installer to obtain information on the zone types and output functions.
9. Step 5d. Assigning function to 433 MHz keyfob button 2. Proceed in the same way as
in Step 5c.
10. Step 5e. Assigning function to 433 MHz keyfob button 3. Proceed in the same way as
in Step 5c.
11. Step 5f. Assigning function to 433 MHz keyfob button 4. Proceed in the same way as
in Step 5c.
12. Step 5g. Assigning function to 433 MHz keyfob button 5. Proceed in the same way as
in Step 5c.
13. Step 5h. Assigning function to 433 MHz keyfob button 6. Proceed in the same way as
in Step 5c.
Pressing the key between Step 5a and Step 5h will cancel the keyfob adding,
but will not terminate the user adding procedure.
14. Step 6. Adding APT-100 keyfob. If the ABAX wireless system controller is connected to
the control panel, the bidirectional APT-100 keyfob can be assigned to the user. Press in
turn and (if a keyfob is to be assigned to the user) or only (if no keyfob
is to be assigned to the user).
15. Step 6a. Selecting APT-100 keyfob addition method. Press (if the keyfob serial
number is to be entered) or press in turn (if the serial number is to be read by
the ABAX wireless system controller during transmission).
16. Step 6b. Adding APT-100 keyfob. Depending on the selected method:
– enter the keyfob serial number and press ,
– press twice any button on the keyfob