16 VERSA SATEL
71. Output 1 deactivation
72. Output 2 deactivation
73. Output 3 deactivation
74. Output 4 deactivation
75. Output 5 deactivation
76. Output 6 deactivation
77. Output 7 deactivation
78. Output 8 deactivation
79. Output 9 deactivation
80. Output 10 deactivation
81. Output 11 deactivation
82. Output 12 deactivation
itchover
over
93. Output 3 switchover
er
er
er
obtain information on the zone types and output functions.
91. Output 1 sw
92. Output 2 switch
94. Output 4 switchover
95. Output 5 switchover
96. Output 6 switchover
97. Output 7 switchover
98. Output 8 switchover
99. Output 9 switchover
100. Output 10 switchov
101. Output 11 switchov
102. Output 12 switchov
Contact the installer to
9. tion to 433 MHz keyfob button 2. Proceed in the same way as
10. ion to 433 MHz keyfob button 3. Proceed in the same way as
11. ion to 433 MHz keyfob button 4. Proceed in the same way as
12. ion to 433 MHz keyfob button 5. Proceed in the same way as
13. ion to 433 MHz keyfob button 6. Proceed in the same way as
Step 5d. Assigning func
in Step 5c.
Step 5e. Assigning funct
in Step 5c.
Step 5f. Assigning funct
in Step 5c.
Step 5g. Assigning funct
in Step 5c.
Step 5h. Assigning funct
in Step 5c.
Pressing the key between Step 5a and Step 5h will cancel the keyfob adding,
but will not terminate the user adding procedure.
14. eyfob. If the ABAX wireless system controller is connected to
the control panel, the bidirectional APT-100 keyfob can be assigned to the user. Press in
Step 6. Adding APT-100 k
turn and (if a keyfob is to be assigned to the user) or only (if no keyfob
ser).
15. -100 keyfob addition method. Press
is to be assigned to the u
Step 6a. Selecting APT (if the keyfob serial
or press in turn
number is to be entered) (if the serial number is to be read by
controller during transmission).
16. 0 keyfob. Depending on the selected method:
l number and press
the ABAX wireless system
Step 6b. Adding APT-10
– enter the keyfob seria ,
To Next Page
Loading...
