SATLINK FLEET ONE Installation Manual Ref: SL00-01191 Ver: 003
Page 6 of 38
Proprietary Information Not To Be Disclosed Without Written Authorisation From
Satlink S.L., All Rights Reserved
SAFETY INSTRUCTIONS
For the sake of safety and protection, read the manual before attempting to use Fleet One
User Equipment (UE).
The following general safety precautions must be observed during all phases of operation,
service and repair of this equipment. Failure to comply with these precautions or with specific
warnings elsewhere in this user guide violates safety standards of intended use of the UE.
Satlink S.L., assumes no liability for the customer's failure to comply with these requirements.
Hazard Symbols
Heat Surfaces
Avoid touching those areas of the UE that are being
marked with this symbol otherwise it may result in injury.
Antenna Radiation Warning
and Distance to other
Radiation Equipment
For safety reasons, all personnel must keep at least
ONE meter from the antenna.
Power Supply
Turn off the power at the mains switchboard before
beginning of the installation.
Confirm the power voltage is compatible with voltage
rating of the equipment. It is highly recommended to use
+24V DC power line, provided that it is available on the
vessel.
If there is no +24V DC power line provided by the vessel,
an external AC/DC power supply with an input of
115/230V AC and an output of +24V DC can be used.
To Next Page
Loading...
Need help?
General