SATLINK FLEET ONE Installation Manual Ref: SL00-01191 Ver: 003
Page 20 of 38
Proprietary Information Not To Be Disclosed Without Written Authorisation From
Satlink S.L., All Rights Reserved
2.1.6 Installing Antenna Unit
The antenna unit should be carefully unpacked and checked for any damage.
The procedure of the installation of the antenna unit is as follow:
Find a suitable place for a stainless steel tube and run cable inside tube
Pass the coaxial cable through the flange and gasket
Attach the coaxial cable to the RF connector on the antenna unit’s base.
Ensure the connection of the coaxial cable and wrap it with self-amalgamating tape
for water-proofing.
Put the antenna unit on the mounting flange and the 6 screw bolts with flat washers
and caps into the threaded holes of the antenna unit’s mounting base via the
mounting flange’s holes.
Position the antenna unit onto the tube by placing the tube inside the tube cap.
Tighten the 3 tube fixing bolts in order to secure it to the tube.
Double check all screws and bolts
2.2 Installation of BDU
The BDU’s box is unpacked and the following items should be checked whether they are
present:
BDU
1 x Primary Handset with Cradle
1 x Ethernet Cable
1 x DC Power Cable
1 x Inmarsat 505 laminated card
1 x Wi-Fi Antenna
Hardcopy Quick Start Guide
CD ROM (Soft User Manual)
Cable Support Kit
To Next Page
Loading...