SATO CL608e/CL612e - Page 128

Page 6-22
Section 6. Replacement Procedures
SATO CL608e/CL612e Service Manual
PN 9001079
Rev. B
Replacing the Platen
Fig. 6-39
Fig. 6-37
PULL PLATEN
THROUGH HOLE IN
FRAME AND OUT THE
ELECTRONICS
COMPARTMENT
Fig. 6-36
DISPLACE PLATEN BY
PULLING UP AND
AWAY FROM HOLDING
CLAMP
Fig. 6-38
HOLDING CLAMP
WITH HEAD RELEASE
LEVER IN PLACE
HOLDING CLAMP
WITH HEAD RELEASE
LEVER REMOVED
FOR CLARITY AND
SHOWING THE
SPRING IN CORRECT
POSITION
BUSHING PLATE
SPRING END MUST
NOT BE UNDER
BUSHING PLATE