Section 3: Configuration and Operation
Page 3-22 LM Basic 408e/412e Operator’s Manual
3.13 HEX DUMP MODE
3.13.1 LCD Status
In the Hex Dump Mode, when data is received, a hex dump is
printed. The LCD screen then shows the quantity of labels printed,
and the printer status.
3.13.2 Hex Dump Mode in buffer
In this mode, only the buffer data is dumped. The quantity of labels
printed is updated on the LCD screen.
The procedure for such a buffer dump is as follows:
1. Make sure the printer is turned OFF.
2. Set DSW2-4 to ON, then press the LINE button to take the printer ONLINE.
4. Send data to the printer.
5. To return to normal mode, turn the printer OFF and set DSW2-4 to OFF.
6. Finally, turn the printer ON again to let the new mode take effect.
ONLINE
QTY: 000000
ONLINE
QTY: 000000
To Next Page
Loading...
Need help?
General
