SECTION 6: TROUBLESHOOTING
Page 6-6 SATO D508/D512 Operator Manual
6.3 CHECKING THE 802.11G WIRELESS INTERFACE
1. Is the antenna properly and completely installed?
2. Is the interface properly seated in the printer?
3. Are the green connection lights on the back of the interface board illuminated?
4. If it is not obtaining an IP address, check the SSID or encryption and ensure those were prop-
erly entered.
5. In order to determine the IP address obtained through the DHCP wireless device, power off
the printer, place switch 3 in the upward position on the wireless card, and reinsert it into the
printer, and power the printer on. Wait approximately 30 seconds for a print out of configurations.
To Next Page
Loading...
