Section 5: Interface Specifications
GT Series Operator’s Manual Page 5-29
5.15 MULTI JOB BUFFER (CONT’D)
(2) Cancel Request Command
In receiving this command, printing is aborted and the contents of the reception buffer are
completely cleared.
The status responded is the status of the printer after this procedure has been completed.
After sending the cancel request command, the next data should be sent after a lapse of more
than 100ms.
i) Command CAN (Hex 18H)
ii) Responded Status Definition
Echo Status Contents
ACK (Hex 06H) Indicates that there is no printer error
NAK (Hex 15H) Indicates that there is a printer error
(3) Print command
In receiving the printing command (ESC+”A” – ESC+”Z”), printing commences.
The status echoed is the status of the printer after the receiving process has been completed.
i) Responded Status Definition
Echo Status Contents
ACK (Hex 06H) Indicates that there is no printer error
NAK (Hex 15H) Indicates that there is a printer error
To Next Page
Loading...
