SATO M-8485Se - Page 53

Section 3. Confi
g
uration
AUTO ONLINE FEED
YES N
O
FEED ON ERROR
Y
ES NO
This selection specifies whether or not the printer will feed a
label when it is placed in the Online mode.
1. Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will feed a blank label anytime it
enters the Online mode. If
No (default) is selected, the
display will advance to the mode display.
This selection specifies whether or not the printer will feed a
label when an error condition is cleared..
1. Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will feed a blank label anytime
an error condition is cleared. If No (default) is selected,
the display will advance to the mode display.
S
A
TO “Se” Print En
g
ines Pa
g
e 3-23
REPRINT W/FEED
YES N
O
This selection specifies whether or not the printer will print
the last printed label stored in memory when the FEED key is
pressed in the Normal Online mode.
1. Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will reprint the last
label when
the FEED key is pressed when the printer is Online. If the
printer is Offline, pressing the FEED key will feed a blank
label. If No is selected, the display will advance to the
next display.
CALENDAR REPRINT
Y
ES NO
If the previous Reprint W/Feed option is set to Yes, and
DSW3-8 is ON, then this menu appears. Set Yes (default) to
have the current calendar date/time to appear on the printed
labels. Select No if you do not want calendar date/time
information in the reprint.
FORWARD/BACKFEED
DISTANCE D
EFAULT
FORWARD/BACKFEED
DISTANCE XXXmm
EXT PIN 9 SELECT
MODE1 MODE2
This display will only appear Backfeed is enabled (DSW3-4
= OFF). The maximum backfeed distance is 255 mm.
1. Use the LINE key to select either the Default or the Manual
selection. If Default is selected, the display steps to the
next display.
2. If Manual setting is selected, use the LINE key to advance
the distance to the desired setting. Each time the LINE
key is pressed, the Distance will advance 1 mm. The
maximum distance is 255 mm.
3. Once the desired distance is set, press the FEED key to
accept the
setting and step to the next display.
This selection allows the user to select the conditions that
cause the signal on Pin 9 of the EXT connector to be true. If
Mode1 is selected, pin 9 will be true when the printer is
ready to print, i.e. it is Online
and has a print job loaded (a
quantity of labels to be printed on the display). If Mode 2 is
selected, pin 9 will be true if the printer is Online.
1. Use the LINE key to step the cursor to the desired setting.
2. Once the desired setting is selected, press the FEED key
to accept the setting and step to the next display.