Section 3. Confi
uration
WEB ACCELERATION
FAST NORMAL
EURO CODE
D5
This selection allows the printer to use either a Normal or Fast
web acceleration. Large, heavy, label rolls should use the
Normal selection while smaller, lighter rolls can use the Fast
selection.
1. Use the LINE key to step the cursor to the desired setting.
2. Once the desired setting is selected, press the FEED key to
accept the setting and step to the next display.
This selection allows the user to specify the dexadecimal code
for the character which is replaced with the Euro Character.
The default is D5
H
.
1. The cursor should be positioned over the first digit
selection. Use the LINE key to step to the desired setting.
2. Press the FEED key to advance the cursor to the second
digit of the desired hexacecimal code.
3. Press the LINE key to step to the desired setting.
4. When the setting is correct, press the FEED key to accept
the setting and step to the next display.
This selection allows the user to select the character set used
by the printer. The selections are English, French, German,
Spanish, Italian and Portuguese.
1. Press the LINE key to advance to the desired languarge
setting.
2. When the setting is correct, press the FEED key to accept
the setting and step to the next display.
This selection allows the user to assign a priority for Print
Darkenss, Print Speed and Print
Offset setting methods. If
LCD is selected, the setting established via the LCD
display/menu system will be used for an incoming label job,
regardless of any different command settings. If Command is
selected, any commands in the label job will take precedence
and be used for printing the job.
1. Use the LINE key to step to the desired priority.
2. Once the desired setting is selected, press the FEED key to
accept the setting and step to the next display.
If the printer is placed in the Multi-Item Buffer Mode (DSW2-5
= OFF), the user can chose to ignore CAN
(18
H
) and DLE
(10
H
) commands used in bi-directional communications (see
Section 6: Interface Specifications). If the Single Item Buffer
Mode is chosen (DSW2-5 = ON), this display will be skipped.
This selection is used to enable (default) or disable the
printer’s sensing of whether a ribbon roll is reaching the end
of its ribbon supply. Use the LINE key to select either option,
and then press the FEED key to confirm the selection.
Pa
e 3-24 SATO
“Se”
Print En
ines
SELECT LANGUAGE
E
NGLISH
PRIORITY SETTING
C
OMMAND LCD
IGNORE CAN/DLE
YES NO
RIBBON NEAR END
E
NABLE DISABLE
To Next Page
Loading...
