Section 7. Label Sheet Commands
SATO M10e PN 9001101 Rev. A Page 7-3
Label Start
COMMAND STRUCTURE <ESC>_F
Example: <ESC>_F
Placement: Following the <ESC>A1 Media Size command.
Default: None
COMMAND FUNCTION To indicate the start of a small label print specification.
PRINTER INPUT <ESC>A
<ESC>A106363060<ESC>PD,600,1020,0,0
<ESC>_F
<ESC>V100<ESC>H200<ESC>L0101<ESC>XMHEADER LABEL
<ESC>_<ESC>Q,1
<ESC>_F
<ESC>V100<ESC>H200<L>L0202<XM>XMABCD
<V>V200<H>H200<ESC>L0202<ESC>B103200*11111*
<ESC>_<ESC>Q,6
<ESC>_F
<ESC>V100<ESC>H200<ESC>L0101<ESC>XMFOOTER LABEL
<ESC>_<ESC>Q,1
<ESC>Z
PRINTER OUTPUT The printer will print the label data following the command.
Special Notes
1. If sequential numbering is specified after start of small label specifica-
tion, sequential number on every small label is printable.
2. You must specify the print noumber of small label with the small label
quantity specification <ESC>_Q.
3. Do not specify the register command after the small label start specifi-
cation <ESC>_F as the printing shall not operate properly as speci-
fied.
To Next Page
Loading...
