To Next PageTo Next Page
Need help?Do you have a question about the Savant IP Audio 1 and is the answer not in the manual?
General| Brand | Savant |
|---|---|
| Model | IP Audio 1 |
| Category | Speaker System |
| Language | English |
Provides special information for installing, configuring, and operating the equipment.
Highlights electrical hazards and the need for accessible power disconnects.
Warns about potential injury due to improper handling during installation.
Lists minimum software releases required for various Savant IP Audio devices.
Details the RJ-45 Ethernet port standard for Savant IP Audio devices.
Provides warnings and recommendations for connecting AC power to devices.
Instructions for safely checking and replacing fuses in specified IP Audio devices.
Guides on wiring 4-pin speaker connectors for specific IP Audio models.
Explains how to wire IR control connections to component devices using 4-pin or 6-pin connectors.
Details RS-232 wiring for specific IP Audio devices using RJ-45 connectors.
Describes GPIO port wiring and usage for triggering system actions.
Explains the relay port functionality for controlling components via NO or NC relays.
Details rack and enclosure mounting options for the PAV-SIPA50SM device.
Describes rack mounting for the PAV-SIPA125SM device.
Covers side-mounting and rack mounting options for the PAV-SIPA1SM unit.
Explains placement on flat surfaces or rack mounting using optional brackets.
Details installation of pre-construction brackets and flush mount kits for speakers.
Guides on selecting and installing mounting brackets for IP Soundbars.
Illustrates a standard Blueprint configuration layout using a Savant IP Audio device.
Step-by-step process for adding an IP Audio device into a Blueprint configuration.
Explains how to group physical I/Os into logical assignments for audio outputs.
Describes how to group AVB audio endpoints into a single audio service.
Details how to access the IP Audio device's Web UI via IP address.
Describes the information available in the Status tab of the Web UI.
Explains the Network tab for configuring IP settings and network status.
Details the Inputs & Outputs tab for managing audio connections and settings.
Covers the Calibration tab for adjusting audio filters like HPF and trim.
Illustrates a Blueprint layout connecting multiple IP Audio devices to an AVB switch.
Steps for adding a Savant supported AVB/TSN switch to a configuration.
Shows a multi-switch AVB deployment configuration using daisy-chained switches.
Displays active AVB connections and device status within System Monitor.
Guides on adjusting input gain for IP Audio devices using System Monitor.
Details adjusting min/max volume levels for audio outputs via System Monitor.
Explains how to adjust the trim for Savant Music 2.0 services in System Monitor.
