Savant IP Audio Deployment Guide Copyright © 2020 Savant Systems, LLC
009-1571-03 | 200224 13 of 39
4.5. IP Micro Aperture Speakers
MRS-4-PCB
Micro Aperture 4 Pre-Construction Bracket. This bracket is to be
used when these speakers are being installed before the ceiling
boards have been installed.
1. Push wings into place (x2).
Wing
2. Once in place, fold tabs on pre-construction bracket down
(x4).
MRS-4-FHK
Micro Aperture 4 Flush Mount Kit. Requires the Micro Aperture 4 Pre-
Construction Bracket.
1. Before drywall, install the mud housing to the pre-construction
bracket using the spacers (x4), and long (20 mm) screws (x4).
(See Notes).
(x4)
(x4)(x4)
(x4)
Mud Housing
Mud Ring
2. Install combined assembly same as above MRS-4-PCB install.
3. After drywall, attach the mud ring using the short (6 mm) screws
to the mud housing.
4. Mud over mesh up to mud wall on the housing. Sand smooth.
NOTES:
– The mud housing may be installed for the round or square
speakers. Mount with the selected shape facing into the room.
– Select the proper spacer for your drywall finish.
– 1/2” use 7 mm spacer.
– 5/8” use 10 mm spacer
To Next Page
Loading...
Need help?
General
