Scalarider FREECOM 4 - Bluetooth Intercom Busy Signal; Click-To-Link Calls

● To add rider A to a call, tap .
● To add rider B to a call, tap twice.
● To add rider C to a call, tap three times.
● To use the SmartSet app: On the INTERCOM screen, select the required channel (A, B or C).
To disconnect the Bluetooth intercom conference call from the mobile call, do one of the following:
● To use the unit buttons:
● To disconnect rider A, tap .
● To disconnect rider B, tap twice.
● To disconnect rider C, tap three times.
● To use the SmartSet app: On the INTERCOM screen, disconnected the active channel.
After disconnecting the Bluetooth intercom call, you can continue talking on the mobile call. Similarly, if you first
disconnect the mobile call, you can continue talking on the Bluetooth intercom call.
5.2.5 BLUETOOTH INTERCOM BUSY SIGNAL
A busy signal is heard when you attempt a Bluetooth intercom call when the other passenger/rider is in a:
● phone call
● Bluetooth intercom call with Channels A and B
● Click-to-Link call
5.2.6 CLICK-TO-LINK CALLS
Click-to-Link is a spontaneous way to instantly initiate one-on-one intercom calls with a nearby passenger/rider,
without being paired.
● If other Cardo users are nearby, your next Click-to-Link call may randomly connect to any of them.
● To block incoming Click-to-Linkcalls, disable Click-to-Link (see Before You Ride on page 12).
To make a Click-to-Link call through the SmartSet app:
1. Open the SmartSet app and tap Intercom.
2. Tap CLICKTOLINK.
To end a Click-to-Link call through the unit buttons:
● Tap .
To accept a Click-to-Link call through the unit buttons:
● Tap .
To reject a Click-to-Link call through the unit buttons:
● Press for 2 seconds.
29