Starting and running
OPM 200 en-GB 25
© Scania CV AB 2020, Sweden
Reductant pump
When the reductant pump is new, the check
valves may need to be slackened.
Blow the reductant pump suction nipple with
compressed air (approx. 6 bar/87 psi) for at least
3 seconds before starting the engine for the first
time.
Start the reductant pump immediately after the
reductant tank has been filled for the first time.
Checks before running
Carry out daily maintenance as described in the
maintenance schedule prior to operation. See
Maintenance interval
.
336 838
Reductant pump suction nipple.
To Next Page
Loading...
Need help?
General
