OPM 200 en-GB 97
© Scania CV AB 2020, Sweden
Miscellaneous
Renewing the particulate fil-
ter
P3 type respiratory protective equipment/filter
mask, eye protection and gloves should be worn
for any work where there is a risk of exposure to
dust from the particulate filter. A face mask,
gloves and eye protection must be worn when
cleaning the filter unit. Use protective equipment
from the time the filter unit is exposed until the
time cleaning is complete. Safety clearance for
unprotected people is 3 m.
Do not eat, drink or smoke while work is in pro-
gress.
Any dust from the particulate filter should be re-
moved using a vacuum cleaner with a HEPA fil-
ter that can filter out particles down to a particle
size of 0.3 microns, in order to reduce exposure.
Wash your hands thoroughly after work on the
particle filter.
Be careful when handling the sensor body. It is
sensitive and must not be bent or straightened.
Renew the sensor if it is bent.
Tools
Number Designation Illustration Tool board
99 405 Clutch bleeder D6
99 654 VCI3 N/A
2 290 856 17 mm, Special socket, slot-
ted, 1/2"
N/A
To Next Page
Loading...
