Scania DC13 XPI - Particulate Filter Maintenance Intervals

Maintenance
OPM 200 en-GB 42
© Scania CV AB 2020, Sweden
Particulate filter maintenance inter-
vals
IMPORTANT!
Scania recommends using Scania LDF-4 engine
oil. The graph can only be used if this condition
is met.
Note:
The Y axis shows the driving time and the X axis
shows the average fuel consumption.
l/ h
h
= A
= B
= C
0
2000
4000
6000
8000
10000
12000
14000
16000
01020304050607080 90
399 425
The diagram shows calculated driving time before particulate filter renewal must be carried out on engines
with the following 3 types of dynamic load:
A = High dynamic load, for example excavator and wheel loader.
B = Semi-dynamic load, for example stone crushing plant and dumper truck.
C = Low dynamic load, for example generator set.