16 © Scania Industrial & Marine Engines 2003-10:1
Action when a fault arises
LED indications in the event of a fault
Note: It is indicated on the main indicator lamp in
the main supply box and on the instrument
panel. The lamp test/fault code switch should
not be depressed.
CONTROL STATUS
< The LED continues to flash even if a fault has
occurred as long as the control unit is powered
up.
POWER-
< If the LED comes on, the control unit has
detected a fault condition which could result in
engine damage if allowed to continue.
The control unit automatically reduces the
power to a special level if this function has
been selected.
Action: If possible reduce engine speed to idle
and conduct troubleshooting according to
instructions on page 17 and the chart on
page 18.
SHUTDOWN
< The LED comes on and the engine is switched
off automatically in the event of a fault so
serious that the engine could be damaged if it is
still in operation.
Action: Conduct troubleshooting according to
instructions on page 17 and the chart on
page 18.
If the engine has not stopped, reduce engine
speed to idle and carry out troubleshooting.
To Next Page
Loading...
