Scania DI13 - Injection system; Electrical system; Material content

OPM 250 en-GB 94
© Scania CV AB 2022, Sweden
Technical data
Injection system
Electrical system
Material content
The values indicate an approximate percentage
for the different materials that make up the en-
gine.
Recycling
Type PDE (unit injector)
Steering system EMS
Fuel filter Paper filter from Scania
Fuel filter with water separator Paper filter from Scania
Type 2-pin, 24 V, DC
Starter motor, standard equipment 2-pin, 24 V, 7.0 kW
Alternator, standard equipment 2-pin, 28 V, 100 A
Materials % by weight
Steel 40
Cast iron (30% recycled) 46
Aluminium 8
Copper, bronze, brass, zinc 1.5
Lead <0.1
Plastic <1
Rubber <1
Glass 0
Paints <1
Oils and greases 3
Type of material Recommended recycling method
Metal Recycling.
Plastic Recycling, incineration.
Chemicals and oils Re-use if possible; otherwise hand in to an authorised waste disposal contrac-
tor.
Fuel filter and oil filter Hand in to an authorised waste disposal contractor.
Colour No known recycling methods.
Electronics Hand in to an authorised waste disposal contractor.