Scania DI13 - Valve Clearance & Unit Injector Adjustment

Miscellaneous
OPM 250 en-GB 74
© Scania CV AB 2022, Sweden
Checking and adjusting the
valve clearance and unit in-
jectors
Special tool
WARNING!
Secure the starting device or remove a battery ca-
ble. If the engine starts unexpectedly, there is a
serious risk of injury.
IMPORTANT!
The engine must be cold when the work is car-
ried out.
Remember to remove the turning tool from the
flywheel following adjustment.
Note:
Carry out the working without pausing, so that
no step is overlooked.
Number Designation Illustration
99 309 Turning tool for rotating the flywheel from below
2 402 509 Turning tool for rotating the flywheel from above
99 442 Setting tool
Other tools
Torque wrench, 0-50 Nm
Waterproof felt-tip pen
0.45 and 0.70 mm feeler gauges
Flash light
Mirror
142 238
312 733
142 436