Lubrication system
OPM 360 en-GB 30
© Scania CV AB 2017, Sweden
13.
Fit the strainer onto the rotor.
14. Fit a new O-ring by sliding it over the strain-
er.
15. Refit the rotor cover. Ensure that the O-ring
is not outside the edges.
16. Tighten the rotor nut by hand.
17. Check that the rotor shaft is not damaged or
loose.
If the rotor shaft needs renewing, the renewal
procedure is described in the Workshop
Manual, which can be ordered from a Scania
dealer or directly from Scania.
18. Refit the rotor and rotate it by hand to check
that it rotates easily.
To Next Page
Loading...
Need help?
General
