Lubrication system
OPM 360 en-GB 31
© Scania CV AB 2017, Sweden
19.
Fit a new O-ring in the cover. Refit the cover
and tighten the lock nut. Tightening torque
15 Nm (11 lb/ft).
To reduce the risk of oil leakage it is important to
tighten the cover to the correct tightening torque.
Operational testing of the
centrifugal oil cleaner
Operational testing need only be carried out if it
is suspected that the centrifugal oil cleaner is
malfunctioning. For example, if the dirt deposit
is abnormally small given the distance driven.
The rotor rotates very fast and should continue to
turn when the engine has stopped.
1. Run the engine until it reaches normal oper-
ating temperature.
2. Turn off the engine and listen for the sound
from the rotor. Use your hand to feel if the
filter housing is vibrating.
3. If the filter housing is not vibrating, disman-
tle and check the centrifugal oil cleaner.
To Next Page
Loading...
Need help?
General
