Lubrication system
OPM 360 en-GB 29
© Scania CV AB 2017, Sweden
8.
Remove the paper insert and scrape away
any remaining dirt deposits inside the rotor
cover. If the deposits are thicker than 28 mm
(1.1 in), the centrifugal oil cleaner must be
cleaned more often.
9. Wash the parts.
10. Inspect the 2 nozzles on the rotor. Ensure that
they are not blocked or damaged. Renew any
damaged nozzles.
11. Check that the bearings are undamaged. Re-
new damaged bearings.
12. Fit a new paper insert inside the rotor cover.
To Next Page
Loading...
Need help?
General
