Figure 1.2 Scan-On plate with tools fitted.
1.6 Range of application
Scanmaskin 650 is exclusively designed to process horizontal surfaces.
Scanmaskin 650 must not be used for other purposes than stated in this user
guide. The manufacturer will not be liable for damage or injury resulting from
incorrect usage of Scanmaskin 650. Failure to follow the directions in this user
guide will void the warranty.
Typical applications
• Removal of old coatings, carpets, putty from hard surfaces
• Removal of undulated concrete surfaces
• Preparation of the surface for coatings
• Polishing of the surface
• Removal of coating defects
• Removal of glue residues
1.7 Scope of supply
The following parts are included with the standard Scanmaskin 650 grinder:
• Key to electrical cabinet
• User guide
If the machine has got a water connection, the counter part for the connection will be
included and fit in the water connection near the handle.
Machines sold outside of Europe will be either equipped with a local standard connector
for the power inlet or the mating connector will be included and fitted at the main power
inlet.
Read “2.6 Electrical safety” before connecting any included connectors.
43
www.scanmaskin.com
SCANMASKIN 650 ENGLISH
To Next Page
