SCANMASKIN 650 - Start up; Stop; Adjusting Grinding Speed; Change Grinding Direction

4.5 Start up
See ”4.1Precautions” before starting the machine.
How to start the machine
Make sure that the power plug and hoses for dust collector and water (if used) are
connected to the machine.
Turn on the dust collector if used.
Push the handle downwards to lift the gear barrel about 10 cm (4”) from the
ground.
Make sure that the “EMERGENCY STOP” button (3) is in its upper position. If not,
release it by turning it clock wise until it rises and press the “STOP” (5) button
once to reset.
Press the “START” (4) button.
Lower the gear barrel down to the floor.
4.6 Stop
How to stop the machine
Press the “STOP” (5) button.
Wait for the machine to come to a complete stop before letting go of the handle.
Turn off the dust collector if used.

4.7 Adjusting grinding speed
Turn the “SPEED” knob (6) clock wise to increase the grinding speed and counter clock
wise to decrease it. See “1.2Mechanical specifications” for the rotation speed range.
4.8 Change grinding direction
Use the “L/R” switch (1) to select grinding direction. The machine will automatically
come to a complete stop and restart in the selected direction.
4.9 Safety off position
When working on the machine, either maintenance or tool change, the machine must be
set to the “Safety off position”. See “2.7Definition of the “Safety off position”” for further
information.
4.10 Grinding
Refer to “Grinding guide” for instructions and information about grinding.
55
www.scanmaskin.com
SCANMASKIN 650 ENGLISH