Users manual Coffee on the Spot
Scanomat A/S Vibe Allé 3. Postboks 131 DK-2980 Kokkedal (Copenhagen) Reg.nr. 236.990
Tel: (+45) 49 18 18 00. Fax: (+45) 49 18 01 18
4
Installation
Service and repair is only to be carried out by service engineers educated by Scanomat.
The coffee brewer is to be secured additionally in accordance with regulations.
The coffee brewer must be earth connected (yellow/green conductor).
Note: If the supply cable (power cord) has been damaged please note that only a maintenance engineer
recommended by the manufacturer is to renew it as special tools are required.
Earth conductor: yellow/green
Neutral conductor: blue
Phase: brown/black
Note: The coffee brewer require ventilation. Therefore there must be a minimum of 50 mm from the back side
of the brewer to the wall. The grating must be inspected frequently and vacuum-cleaned. If the installation
site/environment is especially dusty there must be vacuum-cleaned each month.
Note: Before connecting the coffee brewer draw off some buckets of water by means of the hose (to clean
the pipes and to avoid a disagreeable taste (see draining)). This procedure is also recommended when the
brewer has not been operating for some time.
Note: We recommend that the brewer is switched on permanently due to the ventilation system among others.
Turn off the main switch “I” if the machine is out of operation for a few days.
To Next Page
Loading...
