EasyManua.ls Logo

Scanomat TopBrewer - Chargin Procedure-Evening Close down

Default Icon
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Users manual Coffee on the Spot
Scanomat A/S Vibe Allé 3. Postboks 131 DK-2980 Kokkedal (Copenhagen) Reg.nr. 236.990
Tel: (+45) 49 18 18 00. Fax: (+45) 49 18 01 18
25
d. Check that the mixing bowls and the whipper systems are clean, and clean them if
necessary.
e. Fill the ingredient canisters (only for one day’s use).
f. When the temperature indicated in the display reaches a minimum of 95
o
C, water supply and
power supply can be disconnected. If the machine is not to be used immediately, the power
supply does not have to be disconnected. It can still be connected in order to charge the
batteries.
Note! While water is let into the machine, the machine should be kept under observation.
Charging Procedure (evening – close down):
1) The guiding wheels are locked (H).
2) Take water into the machine (only if the machine is to be used the following day).
3) Switch on electricity:
a. Plug the RCD plug into socket outlet and switch on the socket if necessary.
b. Press reset button and ensure indicator flag shows RED.
c. Press TEST button and ensure indicator flag shows BLACK
d. Press RESET button.
IF EITHER OF THESE TESTS DO NOT PRODUCE THE RESULTS STATED DO NOT USE
THE MACHINE, SEEK EXPERT ADVICE.
WARNING: DO NOT expose RCD plug to damp or humid condition during use.
4) While water is taken into the machine a symbol of a tap will be shown in the display. After 2-3
minutes this symbol will disappear and the water supply can be disconnected.
5) While the machine is taking in water, the machine can be cleaned (see also “daily maintenance”).
a) Check whether undissolved remnants of chocolate, milk, or coffee in the mixing and whipper
system are left. Clean if necessary with a soft brush.
b) Place a small pot or the like under the coffee brewer’s outlet spouts.
c) Press the “service key” on the inner side of the door of the coffee brewer.
d) Press “clean” – the machine will start a cleaning programme.
e) When the machine has finished the cleaning programme, push the “service key” once again.
f) Empty the drip tray, and wipe the machines with a damp cloth.

Other manuals for Scanomat TopBrewer

Related product manuals