Users manual Coffee on the Spot
Scanomat A/S Vibe Allé 3. Postboks 131 DK-2980 Kokkedal (Copenhagen) Reg.nr. 236.990
Tel: (+45) 49 18 18 00. Fax: (+45) 49 18 01 18
27
1) Use hot water with a mild soap solution.
2) Empty the canisters.
3) Remove remnants, if any.
4) Dismount the ingredient throw auger by pulling out the two snap locks, thus it is possible to pull out the
auger. Rinse auger and ingredient canister in the hot water with mild soap solution. Do not re-install the
ingredient canister and auger until they are completely dry.
5) Re-mount the ingredient canisters and fill up with ingredients for one day's consumption. Please make sure
that the canisters are completely dry before filling.
Note! We recommend that water is drawn off the machine and replaced by fresh water after holidays or
weekends when the brewer has not been in operation for some time.
Trouble Shooting:
Problem Possible Cause
No operation at all Main switch (I) might be off
Press switch (A)
Coffee brewer only dispenses No ingredients in the canisters,
water Make sure the augers are turning when operating
A water tap symbol flashes Check that the water supply has
in the display been connected. Activate flush programme.
A thermometer appears in the Press the button G on the panel behind the Trolley
display door.
Clogged mixing bowl or Dismount and clean the mixing
whipper units (see "Daily Maintenance")
Dripping from outlet spouts Activate flush programme a couple of times
Dripping from the overflow Check if the overflow tube going from the bottom
at the bottom of the Trolley. water tank to the over heat switch and the condensing
tube is not having low spots (there must be no
water looms inside the tube).
To Next Page
Loading...
