Users manual Coffee on the Spot
Scanomat A/S Vibe Allé 3. Postboks 131 DK-2980 Kokkedal (Copenhagen) Reg.nr. 236.990
Tel: (+45) 49 18 18 00. Fax: (+45) 49 18 01 18
26
6) Leave the electricity connected over night in order to charge the batteries. The cable for the
connection is let out through the top lid by the rubber lead-in in order to lock the lid.
Start-Up (Morning)
1) Activate the cleaning programme as mentioned in section “Charging” items 5-10.
Fill new ingredients into the canisters of the coffee brewer (only for one day’s use)
Charge condition:
When charging the batteries you can see the condition on the lamps ”B”.
Switch ”A” = ”start switch”.
Scanomat charger:
Orange light: Quick charge.
Yellow light: Ballancing Charge (batteries charged 80% - 95%)
Green light: Float charge (batteries 100% charged)
Draining:
If the machine is not to be used for several days the water tank must be emptied the following
way:
a) The drain hose (part of the delivery) is mounted on the blue nipple “C” at the bottom of the machine.
b) The Drain hose is let into the waste pipe or into a bucket.
c) The blue drain cock “F” is opened (the drain cock is shown in open position).
Warning! Danger of scalding!
d) By pushing the green key “E”, the water will be let out. Keep pressing on key “E” until the water is
not running out anymore.
e) Shut off drain cock “E”
f) Do not forget to empty the ingredient canisters.
Note! After fully charging the batteries (see section charge condition), the coffee brewer’s main
switch must be turned off.
Preventive Maintenance:
The ingredient canisters are to be cleaned at fixed intervals depending on the performance of the machine and
in which environment the machine is installed as well as the quality of the drinking water in the area.
To Next Page
Loading...
