Users manual Coffee on the Spot
Scanomat A/S Vibe Allé 3. Postboks 131 DK-2980 Kokkedal (Copenhagen) Reg.nr. 236.990
Tel: (+45) 49 18 18 00. Fax: (+45) 49 18 01 18
7
Temperature / counter / battery voltage, shown in steps on the display:
Step 1: When the heating element is active, an “H” will be flashing in front of the
temperature reading.
Step 2: A counter will count down for each drink and show the capacity of cups left
indicating when it is necessary to fill the water tank.
Step 3: (Optional) Battery voltage is shown in the display (must be min. 22 Volt and
max. 29 Volt).
WATER VALVE Will be active if the water tank is not completely full. In this situation, pressing a selection
key will cause the coffee brewer to take in water thereby filling the tank completely
before starting the brew. If the tank can not be filled within 5 seconds, the brew will not
be made.
Will be flashing if the level in the water tank is critically low. In this situation no drinks
can be made and the heating element will be disabled. Pressing a selection key will cause
the coffee brewer to attempt to take in water for a maximum time of 3 minutes. If this is
not enough to fill the tank the key press must be repeated
THERMO METER Will be flashing if the temperature in the hot water tank is too low. No drinks can be
selected in this situation..
CUP Will be flashing during brew. Also used to indicate the size of the cup during adjusting
this.
CARAFFE Will be on when a carafe is pre-selected.
ADDITIONAL INFO Used during programming of timers.
MAGNETIC CARD Used during reading magnetic keys: - CREDIT KEY and QUALITY KEY.
To Next Page
Loading...
