Users manual Coffee on the Spot
Scanomat A/S Vibe Allé 3. Postboks 131 DK-2980 Kokkedal (Copenhagen) Reg.nr. 236.990
Tel: (+45) 49 18 18 00. Fax: (+45) 49 18 01 18
23
main switch (see point 1 on the General Drawing). Please note that only the low voltage control circuit
will be cut off, the mains power will not be cut off.
1. Rinse in hot water with a mild soap solution.
2. Switch off the main switch ("I") of the coffee brewer. Light and text in the display will disappear.
3. Dismount outlet holder, "E", and clean by means of the cleaning brush.
4. Clean outlet hoses, "F", by means of the cleaning brush.
1. Dismount ingredient funnels, "B", and wash in hot water with a mild soap solution (dismount by lifting the
hinges).
2. Dismount mixer
bowls and
whipper houses
"C" and "D" by
tur-ning the
whipper house "D"
to the right and
pulling out. Clean
in hot water with a
mild soap solution.
3. Note: Beware
only to dismount
the whipper-blade,
"O", if it is
necessary, by
means if there is
dirt inside the
silicone bellow or
if the white teflon
seal can`t move
freely forth and back on the shaft. Note: If the whipper blade, “O”, is dismounted, please se to it that it
is re-mounted correctly (the arrow must point towards the flat part of the shaft, and the blade must be
pressed over the shaft till it clicks). Note: Beware not to damage the white teflon seal. It only may be
cleaned with a soft brush. It is recommended to change the impellor, bellow and teflon seal minimum
once a year.
4. Empty and wash drip tray “H” and mesh “T”.
5. Wash cabinet, door, whipper area and dispensing area. Use a light detergent solution and hot water.
6. Re-mount whipper houses and ingredient funnels, "D" and "B". The funnels must be completely dry
before re-mounting (see instruction on the inside of the door).
7. Switch on the coffee brewer.
8. Flush the brewing system:
a) Place a pot under the dispensing spouts.
b) Press the Service Switch on the inside of the door, the display will show "SERVIC".
c) Press "CLEAN".
d) When the flush programme has been carried out, press the Service Switch. It is possible to
stop the flush programme at any time just by pressing "STOP".
9. Fill the machine with ingredients for one day´s consumption only. It is of the utmost importance that you
observe this recommendation as ingredients easily absorb moisture.
To Next Page
Loading...
